Skip to content

Module 04 · Lesson 13

Troubleshooting mid-service

Six problems, their likely causes and the fix, in the order to try them.

Sunday morning5 min
ProblemLikely causeFix
Feedback squeal / howlMic hears a speaker; monitor too loud; mic far from mouthPull the fader first, then notch the frequency. Move the mic or wedge; get the mic closer to the source.
Muddy, boomy mixToo much 200–400 Hz everywhere; no high-pass filtersHigh-pass everything except kick, bass, organ. Cut low-mids on keys and guitars.
Can't understand the pastorSpeech buried under music; room reverb; mic placementHigh-pass 100–150 Hz, gentle 2–4 kHz lift. Music down during speech. Check the mic sits near the mouth.
Hum or buzzGround loop, damaged cable, unbalanced lines near powerSwap the cable, use a DI with ground lift, keep audio cables away from power.
Harsh crackle / distortionGain too high: clipping at preamp, bus or ampCheck meters from gain to amp clip lights; reduce where the red appears.
Band drowning vocalsInstruments occupy 2–4 kHz; stage volume too highCarve 2–4 kHz in keys and guitars; turn stage amps away or use IEMs.