Module 03 · Lesson 11
Active, passive and where speakers go
Where the amplifier lives, and the one job of every speaker in the building.
Power and speakers7 min
| Topic | Active (powered) | Passive |
|---|---|---|
| Amplifier | Built in, matched by the factory | External rack amp |
| Cables | XLR signal + mains power at each box | Speaker cable only, no power at the box |
| Protection | Built-in limiter and tuning | Depends on your processor & settings |
| Weight | Heavier box | Lighter box, heavy amp rack |
| If it fails | Whole box goes for repair | Swap the amp or the speaker |
| Best for | Portable setups, small churches, monitors | Fixed installs, flown speakers, big rooms |
| Speaker | Its job |
|---|---|
| Mains / FOH | Main left/right (or centre) aimed at the congregation. Example: two 12″ two-way boxes on stands for 150 seats. |
| Subwoofers | Only the lowest notes, below about 100 Hz, fed via the crossover. Many churches use one or two, not a wall. |
| Stage monitors | Wedges or in-ear monitors (IEMs) so the team hears itself. IEMs cut stage volume, so the house mix gets cleaner. |
| Front & side fills | Small speakers covering rows the mains miss. Low level, just enough to fill the gap. |
| Delay speakers | Under balconies or at the back of long rooms, time-aligned by the processor. |
| Line array vs point source | Line arrays throw evenly over long distances; point source suits most small and medium sanctuaries. |