Skip to content

Module 03 · Lesson 10

Amplifiers and matching

A whisper in, speaker power out. Match the ohms, then add headroom.

Power and speakers8 min

The amp doesn't create sound: it copies the console's waveform exactly, just much bigger, from line level (about 1 V) to speaker level (tens of volts). Input sensitivity (e.g. 1.4 V) is the input level that drives it to full power.

ClassHow it's built
Class ABClassic linear design. Heavy transformer and heat sinks, roughly 50–70% efficient; the rest becomes heat.
Class DSwitching design used in most modern pro amps and active speakers. Light, cool, often around 90% efficient.
Class HAn AB amp that switches to higher supply rails only for big peaks: more efficient than plain AB.
ModeUse it for
StereoTwo channels, two different signals, e.g. left and right mains.
ParallelOne input feeds both channels, e.g. two monitor wedges with the same mix.
Bridge monoBoth channels work as one big channel for a sub. Check the minimum load; often 8 Ω.

Matching amps to speakers

Parallel: R = (R1 × R2) ÷ (R1 + R2)   →  8 Ω + 8 Ω = 4 Ω
Series:   R = R1 + R2               →  8 Ω + 8 Ω = 16 Ω
Parallel (most common) halves the load and makes the amp work harder. Series is safe for the amp but gives less power.