Skip to content

Module 03 · Lesson 09

Cap placement & adjustment

The cap is the foundation: if it sits wrong, everything on it sits wrong.

Measuring & prep4 min
  1. 1

    Find the hairline. Pull the cap so its front edge sits just behind where the lace will go.

  2. 2

    Pin it flat. Pin the centre front, then temples, then over the ears, then the nape, smoothing as you go.

  3. 3

    Remove slack. Pinch extra fabric at the back or sides and sew a small fold (a dart) to tighten it.

  4. 4

    Check the ear tabs. Ear tabs sit in front of the ears. Trim the ear curve if it presses.

  5. 5

    Measure again. Check the cap on the block against the client's measurements before sewing.

You'll need

  • Dome cap
  • T-pins
  • Needle & thread
  • Tape measure
  • Scissors

Your turn

Practise it

Watch the technique once, repeat it on your own block step by step, check your work against the steps above, then do it again until it's neat. Time yourself on the last try.